| You will need this hardware to assemble your bike generator stand. | ||
 |  |  |
| 5/16-18 3' THR ROD 18-8 S/S Pkg Qty. / 1
| Hillman #100407 100PK 1/4-20x2 FH Screw
$11.99 These screws are used to secure the generator / motor to the square bar. you need 4 of them. | 5/16-18 HEX NUT ZINC Box Qty. / 100
You need a total of 3 of these nuts. You will use them on steps 4 and 5 of the bike generator stand conversion instructions. |
 |  |
|
| 48' HEAT SHRINK TUBING WRAP SLEEVES ASSORTE...
You only need a little bit of this heat shrink. This will be used to cover bare wires after they have been soldered together. ... | 1/4 X 4 CARRIAGE S/S Box Qty. / 25
Thes bolts are used with springs to push the bike generator in the upward direction. This will keep the rubber roller from sl... |
|
Required Hardware
